An engineer is trying to copy an IOS file from one router to another router by using TFTP. Which two actions are needed to allow the file to copy? (Choose two.)

A.

Copy the file to the destination router with the copy tftp: flash: command

B.

Enable the TFTP server on the source router with the tftp-server flash: <filename> command

C.

TFTP is not supported in recent IOS versions, so an alternative method must be used

D.

Configure a user on the source router with the username tftp password tftp command

E.

Configure the TFTP authentication on the source router with the tftp-server authentication local command

Refer to the exhibit.

An engineer is troubleshooting BGP on a device but discovers that the clock on the device does not correspond to the time stamp of the log entries. Which action ensures consistency between the two times?

A.

Configure the service timestamps log uptime command in global configuration mode.

B.

Configure the logging clock synchronize command in global configuration mode.

C.

Configure the service timestamps log datetime localtime command in global configuration mode

D.

Make sure that the clock on the device is synchronized with an NTP server.

While troubleshooting connectivity issues to a router, these details are noticed:

Standard pings to all router interfaces, including loopbacks, are successful.
Data traffic is unaffected.
SNMP connectivity is intermittent.
SSH is either slow or disconnects frequently.
Which command must be configured first to troubleshoot this issue?

A.

show policy-map control-plane

B.

show policy-map

C.

show interface | inc drop

D.

show ip route

Refer to the exhibit.

The network administrator configured VRF lite for customer A. The technician at the remote site misconfigured VRF on the router. Which configuration will resolve connectivity for both sites of customer_a?

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Refer to the following output:

Router#show ip nhrp detail

10.1.1.2/8 via 10.2.1.2, Tunnel1 created 00:00:12, expire 01:59:47
TypE. dynamic, Flags: authoritative unique nat registered used
NBMA address: 10.12.1.2
What does the authoritative flag mean in regards to the NHRP information?

A.

It was obtained directly from the next-hop server.

B.

Data packets are process switches for this mapping entry.

C.

NHRP mapping is for networks that are local to this router.

D.

The mapping entry was created in response to an NHRP registration request.

E.

The NHRP mapping entry cannot be overwritten.

Refer to the exhibit.

AAA server 10.1.1.1 is configured with the default authentication and accounting settings, but the switch cannot communicate with the server Which action resolves this issue?

A.

Match the authentication port

B.

Match the accounting port

C.

Correct the timeout value

D.

Correct the shared secret

Refer to the exhibit.

An engineer is trying to block the route to 192.168.2.2 from the routing table by using the configuration that is shown. The route is still present in the routing table as an OSPF route. Which action blocks the route?

A.

Use an extended access list instead of a standard access list.

B.

Change sequence 10 in the route-map command from permit to deny.

C.

Use a prefix list instead of an access list in the route map.

D.

Add this statement to the route map: route-map RM-OSPF-DL deny 20.

Which statement about IPv6 RA Guard is true?

A.

It does not offer protection in environments where IPv6 traffic is tunneled.

B.

It cannot be configured on a switch port interface in the ingress direction.

C.

Packets that are dropped by IPv6 RA Guard cannot be spanned.

D.

It is not supported in hardware when TCAM is programmed.

Refer to Exhibit.

Which statement about redistribution from BGP into OSPF process 10 is true?

A.

Network 172.16.1.0/24 is not redistributed into OSPF.

B.

Network 10.10 10.0/24 is not redistributed into OSPF

C.

Network 172.16.1.0/24 is redistributed with administrative distance of 1.

D.

Network 10.10.10.0/24 is redistributed with administrative distance of 20.

Which command allows traffic to load-balance in an MPLS Layer 3 VPN configuration?

A.

multi-paths eibgp 2

B.

maximum-paths 2

C.

Maximum-paths ibgp 2

D.

multi-paths 2

Refer to the exhibit.

Which routes from OSPF process 5 are redistributed into EIGRP?

A.

E1 and E2 subnets matching access list TO-OSPF

B.

E1 and E2 subnets matching prefix list TO-OSPF

C.

only E2 subnets matching access list TO-OSPF

D.

only E1 subnets matching prefix listTO-OS1

Which label operations are performed by a label edge router?

A.

SWAP and POP

B.

SWAP and PUSH

C.

PUSH and PHP

D.

PUSH and POP